Material properties required to run FEA analysis on Laminate

[jeevan.robinson]

I am working on project to study FEA vs experimental data correctional. Plotting deflection vs load curve data to understand the trend. I am looking for ASTM standards to calculate Orthotropic Elasticity of Young’s Modulus, Poisson’s Ratio and Shear Modulus as input value in ANSYS. Could you recommend the best wood material modeling? Your help and feedback is greatly appreciated.
Thanks Jeevan

[Fern Thomassy]

Anonymous posts are not welcome on the XANSYS list. Please review the Rules page and the "Announcement" posts at the top of the Forum. We recommend all members automate signatures (including at least your full name and affiliation) in your email tool and Forum profile.

---
Martin Liddle, XANSYS moderator, Tynemouth Computer Services, Chesterfield, UK.
Fern Thomassy, XANSYS moderator, Fallbrook Technologies, Cedar Park, Texas, USA.
Kenneth Gomez, XANSYS moderator, INTECSEA Engineering, Perth, Australia.


-----Original Message-----
From: XANSYS [mailto:xansys@xansys.org]
Sent: Thursday, August 06, 2015 4:44 PM
To: xansys@xansys.org
Subject: [Xansys] Material properties required to run FEA analysis on Laminate

I am working on project to study FEA vs experimental data correctional. Plotting deflection vs load curve data to understand the trend. I am looking for ASTM standards to calculate Orthotropic Elasticity of Young’s Modulus, Poisson’s Ratio and Shear Modulus as input value in ANSYS. Could you recommend the best wood material modeling? Your help and feedback is greatly appreciated.
Thanks Jeevan


PRIVILEGED AND CONFIDENTIAL COMMUNICATION This electronic transmission, and any documents attached hereto, may contain confidential and/or legally privileged information. The information is intended only for use by the recipient(s) named above. If you have received this electronic message in error, please notify the sender and delete the electronic message. This message is protected by copyright laws and any disclosure, copying, distribution, or use of the contents of information received in error is strictly prohibited.
+-------------------------------------------------------------+
| XANSYS web - www.xansys.org/forum |
| The Online Community for users of ANSYS, Inc. Software |
| Hosted by PADT - www.padtinc.com |
| Send administrative requests to xansys-mod@tynecomp.co.uk |
+-------------------------------------------------------------+

Post generated using Mail2Forum (http://www.mail2forum.com)
_________________
Martin Liddle, XANSYS moderator, Tynemouth Computer Services, Chesterfield, UK.
Fern Thomassy, XANSYS moderator, Fallbrook Technologies, Cedar Park, Texas, USA.
Kenneth Gomez, XANSYS moderator, INTECSEA Engineering, Perth, Australia.